FAQ

Home > Support > FAQ

When Does a Hawe GZ3 Seated Valve Beat a Spool Valve?

Author: EFFSEN AUTOMATION | HONGKONG | Date: 2026-11-17

Spool-type directional valves are the default choice in most hydraulic circuits, and for good reason - they are cheap, fast and easy to stack. But every spool valve leaks internally by design, because the spool needs clearance to move. In a clamping, press or holding circuit that clearance translates into real drift: a load that creeps, a fixture that loosens overnight, a safety function you cannot certify. Hawe built the GZ3 series directional seated valve specifically for those cases - a spring-loaded ball seat that shuts metal-to-metal and holds pressure with no measurable internal leakage, at working pressures up to 500 bar with peaks to 700 bar.

The GZ3 is a 3/2-way seat valve, available with solenoid, hydraulic-pneumatic, mechanical or manual actuation, and it mounts on subplates per Hawe's D7300 standard or directly in manifold blocks. Because the ball is pressed against its seat by a spring rather than held centered by fluid balance, the valve switches cleanly even after long stationary periods - no sticking, no sticking-related scoring, and a smooth shock-free transition thanks to the lever mechanism between actuator and ball.

Seated valve vs spool valve - the practical difference

CriterionHawe GZ3 (seated)Conventional spool valve
Internal leakage when closedPractically zero (ball seat)Always present (spool clearance)
Max working pressure350-500 bar, peaks to 700 barTypically 250-315 bar
Max flow (series)6 to 120 L/min by nominal sizeWide, but leakage grows with pressure
Holding behaviorLoad stays put indefinitelyLoad drifts, needs a brake or check
Best dutyClamping, pressing, test rigs, safety holdingContinuous cycling, metering, open-center circuits

Before ordering, check five things:

  • Nominal size against flow - the GZ3 family spans roughly 6 to 120 L/min; size the seat for peak flow, not average, or you will hear cavitation at full stroke.
  • Actuation - solenoid (e.g. GZ3-1-A24, 24 V DC), hydraulically pilot-operated, mechanically cam-operated, or hand lever; pick the one your safety chain actually requires.
  • Leak-free direction of use - the valve blocks P-to-A reliably; if you need leakage-free blocking on a second path, combine it with an inserted check valve rather than expecting one seat to do both.
  • Subplate or manifold - D7300 standard subplates accept O-ring sealed ports; custom blocks need the port pattern from the GZ3 data sheet.
  • Media temperature - standard seals suit mineral oil from -20 to +80 degrees C; hotter media calls for the FPM seal variant.

One last habit worth adopting: whenever a customer complains about a press or clamp that "slowly loses position", measure the internal leakage of the existing spool valve before touching the pump. In most of those circuits the spool is the culprit, and a GZ3 swap fixes the drift without any other change.