A Cut-to-Length Retrofit That Started With a Measuring Wheel: The Hengstler RI58-D Math
A packaging machine builder called us last spring about a retrofit that looked trivial on paper: a cut-to-length unit on an existing bagging line was cutting short, and the rotary encoder feeding the counter had been replaced twice with no improvement. The old encoder was a generic 500-PPR unit mounted on the measuring wheel shaft through a worn-out coupling, and the line ran at speeds nobody had ever written down.
We started with the numbers instead of the parts list. The measuring wheel is 200 mm in diameter, so one revolution covers about 628 mm of film. The bag length tolerance is ±0.5 mm, and as a rule of thumb you want the counting resolution at least four times finer than that, so roughly 0.1 mm per pulse. Dividing 628 mm by 0.1 mm gives a target of about 6,000 pulses per revolution — and that happens to be a standard pulse count on Hengstler's RI58-D series, which was the first piece of luck in the whole job.
Then the speed and the cable, in that order
Speed came next. The line tops out at 30 m/min, which is 500 mm of film per second, so a 6,000-PPR encoder on that wheel produces roughly 4,800 pulses per second at full speed. That sits comfortably inside what the RI58's output stage handles without a second thought, and it also means the counter input on their existing PLC, rated to 20 kHz, had plenty of headroom. Nobody had measured any of this before; the previous encoder had probably been fine on resolution and failing mechanically instead.
The cable run from the wheel to the cabinet is about 15 m alongside motor cables, which settled the electrical interface: the RI58-D version with 10–30 V supply and RS422 line-driver output, not a push-pull type. Differential signalling on a run like that is the difference between a clean count and mystery pulses every time the bag sealer fires. Mounting on the wheel shaft through a rigid coupling with a proper torque arm finished the mechanical side, and the encoder's solid-shaft design with the flange options in the series made that a bolt-on exercise.
The line has now cut about two million bags since the change, still within ±0.5 mm. The lesson we keep relearning on these jobs is that the encoder is rarely chosen by math and almost always by habit — and that ten minutes with a wheel circumference, a target tolerance and a top line speed beats another round of swapping parts. If the same machine ever needs shaft-position memory through a power cycle, that is the point where an absolute ACURO encoder enters the conversation, but for pure counting duty the RI58-D remains the boring, correct answer.



