FAQ

Home > Support > FAQ

Moving Powder With Compressed Air Alone: What to Settle Before You Size a Piab piFLOW Conveyor

Author: EFFSEN AUTOMATION | HONGKONG | Date: 2026-11-22

The first thing worth knowing about Piab's piFLOW conveyor line is that it has no motor. Every model moves powder with compressed air alone, using the company's COAX cartridge technology — a multistage ejector that builds vacuum more efficiently than a single-stage venturi, and does it inside a cartridge you can swap without tools. Even the controls are pneumatic, which is why these conveyors end up in places where electricity near the product is a headache: ATEX dust zones, washdown food areas, and older plants with no spare panel space.

The line splits into three families, and choosing between them is mostly about the product rather than the machine. piFLOW i is the industrial generalist for powders and granulates with no special hygiene demands. piFLOW f adds food-grade construction where the material touches product, with surfaces and seals selected for cleaning. piFLOW p is the premium version for pharmaceutical and fine chemical duty, where documentation matters as much as hardware — Piab can supply IQ/OQ templates for it, and the contact parts come in 316L stainless.

Capacity and distance are the two numbers that decide whether a vacuum conveyor is even the right tool. Throughput runs from roughly 250 kg/h on the smallest units up to around 10,000 kg/h on the largest, depending on the powder's bulk density and how freely it flows. On distance, the practical ceiling is about 25 to 30 feet of vertical lift with no accessories, extendable to around 80 feet with a pipe-emptying solution, and horizontal runs of up to 50 metres are realistic when the lift stays modest. Powders that are cohesive, wet or poorly flowing will never reach the brochure numbers, and liquids are simply out of scope.

Sizing is best done backwards from the receiving vessel. Work out the batch size and the time window, derive the required transfer rate, check the vertical and horizontal legs of the route, then let the air consumption fall out of the manufacturer's figures rather than guessing. One honest warning from the field: the conveyor does not dose. Material is metered before or after the transfer, usually by a loader valve or a weigh hopper, and treating the conveyor as a feeder is a common first mistake.

Maintenance is lighter than most buyers expect. The moving parts are the filter and the seals; the COAX cartridges themselves are wear-tolerant and cheap to hold as spares. Piab's warranty runs five years on complete conveyors and pumps, excluding the electromechanical pump variants, which tells you something about how well the all-pneumatic approach holds up. Disassembly for cleaning needs no tools on most models, which matters more than it sounds on lines that change product weekly.

If there is one shortcut that saves the most grief, it is sending Piab or its distributor three facts early: the powder and its bulk density, the route sketch with the vertical lift marked, and the required hourly rate. With those, the model choice and the pump size are usually settled in one email, and the rest is installation detail.